FRAM SPI(for G.U)
MB85RS4MLY
产品概述
MB85RS4MLY adopts the Serial Peripheral Interface (SPI).
The MB85RS4MLY is able to retain data without using a back-up battery, as is needed for SRAM.
The memory cells used in the MB85RS4MLY can be used for 1013 read/write operations, which is a significant improvement over the number of read and write operations supported by Flash memory and E2PROM.
As MB85RS4MLY does not need any waiting time in writing process, the write cycle time of MB85RS4MLY is much shorter than that of Flash memories or E2PROM.
■ FEATURES
• Bit configuration : 524,288 words × 8 bits
• Serial Sector Region : 256 words × 8 bits
In this region, data storage after (by) three times reflow based on JEDEC MSL-3 standard condition is guaranteed.
• Unique ID
• Serial Number : 64 bits
In this region, data storage after (by) three times reflow based on JEDEC MSL-3 standard condition is guaranteed.
• Serial Peripheral Interface : SPI (Serial Peripheral Interfaces)
Correspondent to SPI mode 0 (0, 0) and mode 3 (1, 1)
• Operating frequency : 50 MHz (Max)
• High endurance : 1013 times / byte
• Data retention : 10 years (+85 °C)
2 .75years (+105 °C)
0.85 years (+125 °C) or more
Under evaluation for more than 2.5years(+125 °C)
• Operating power supply voltage : 1.7 V to 1.95 V
• Low power consumption : Operating power supply current 3.5 mA (Max@50 MHz)
Standby current 340 μA (Max)
• Operation ambient temperature range : - 40 °C to +125 °C
• Package : 8-pin plastic SOP 208mil
8-pin plastic DFN 5mm × 6mm